Filter
Top Products
19
RQT5518
2
1
3
4
5
SA-DA10 SA-DA8
1
BALANCE
TOP MENU
DISPLAY
DVD
ENTER
MENU
STEREO
DELAY
SURROUND
SFC TEST
MUTING
DIMMER VOL
TV VOL
TV/AV
123
DIRECT TUNING/
DISC ENTER
456
≥10/–/– –
7
890
+–
+–
LEVEL
DISC/DECK
1/2
DVD 6CH
+
–
1
4
7
0
89
56
23
DIRECT TUNING/
DISC ENTER
VOLUME
MUTING
≥10/ENTER
DISC/DECK 1/2
MD
SOUND MODE
SFC
SLOW/
SEARCH
DELAY
TOP MENU
ENTER
MENU
DISPLAY RETURN
SUB TITLE
AUDIO ANGLE
+
–
LEVEL
TEST
GROUP
–+
DIMMERPAGE
-/--
DVD
2
3
4
5
3
4
5
2
TEST
TEST
SPEAKERS
AB
BI-WIRE
VOL
+–
+
–
VOLUME
LEVEL
LEVEL
+–
+
–
SA-DA10 SA-DA8
SA-DA10 SA-DA8
SA-DA10 SA-DA8
SA-DA10 SA-DA8
SPEAKERS
A
LCRRSLSSW
C
RS LS SW
Preparation
Preparatory steps
Adjusting speaker output level
Adjust speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source.
1 Press [A] or [BI-WIRE] to turn on
SPEAKERS.
A or BI-WIRE refer to the speaker terminals at the rear of
the unit.
You cannot adjust output level when SPEAKERS B is
selected.
2
by remote control only
Press [TEST] to output the test signal.
“TEST” appears on the display.
The signal is output from each speaker in order for about
two seconds each:
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as “NONE” or “NO” are skipped.
Note
DSP sound mode switches to SURROUND mode when the
test starts.
3
by remote control
Press [VOLUME (+ or –)] (SA-DA10) or
[VOL (– or +)] (SA-DA8) to set the
volume level normally used for
enjoying the source.
Note
Use [BALANCE] if the left right balance of the front
speakers is off.
4
by remote control only
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as “NONE” or “NO” are skipped.
5
by remote control only
Press [+] or [–] to adjust the level to
the same apparent level as the front
speakers.
The four channels can be adjusted between –10 dB and
+10 dB, with zero being the current level of the front
speakers.
6 Repeat 4 and 5 for each speaker
channel.
To stop the test signal
Press [TEST].
Note
The test signal will not be output if VGCA is ON (a page 27).