Filter
Top Products
44
There is no sound or only a very low-level sound is heard.
e Adjust the volume.
e Check the connection to the speakers.
e Check the DIGITAL AUDIO SETUP (DIGITAL OUTPUT) (page 35).
e The sound is muted during pause and fast forward/reverse. Press
the Play/Pause (y/J) button to resume normal playback.
No digital audio output.
e
Check that the DIGITAL AUDIO SETUP (DIGITAL OUTPUT) is set to
“ALL” or “PCM only” (page
35
).
Digital audio recording is not possible on another device.
e
Check that the DIGITAL AUDIO SETUP (DIGITAL OUTPUT) setting is
set to “PCM only” (page
35
)
.
e Copy-prohibit material cannot be copied digitally.
No picture/distorted picture
e Check the connection to the TV (monitor)
e Check the operating instructions for the TV (monitor) to make
sure that you have the right input selected, etc.
e If you are using a HDMI connection, make sure it is configured
correctly (page 37).
e When your TV/monitor is not compatible with Progressive
scan, never set the TV MODE setting to “PROGRESSIVE”
(page 36).
Picture noise.
e If video from this system has to go through your VCR to get to
your TV, the copy-protection applied to some DVD programmes
could affect picture quality. Please connect the unit directly to
your TV.
The image is distorted or monochromatic.
e Make sure that the PAL-NTSC setting matches the TV/monitor
(page 37).
e Adjust the aspect ratio to correspond to the TV/monitor in use
(page 34).
The aspect ratio of the screen cannot be changed.
e The aspect ratio might be fixed by the disc.
Picture and sound do not match up.
e With some TV sets there may be a short pause from when the
video signal is received until the image appears. If the sound from
the speaker does not match the TV image, minimize the volume
level of the MC-DV600 and output the sound from the TV.
e Try to correct the picture and sound sync problem using the
procedure described on page 35 “AUDIO SYNC”.
FM tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Check the antenna connection and reconnect it securely.
e Rotate or extend the antenna for the best reception position.
Though the broadcast is stereo, it sounds monaural.
e Press the FM MODE button (page 39).
Troubleshooting(2)
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again. This resets the internal
micro-computer which can be disturbed during electrical
storms, power interruptions, etc.
If unplugging the power cord does not solve the problem, try the
following procedure to reset the internal micro-computer.
1. Turn the unit on.
2. Press the Stop (H) button while holding down the Play/Pause
(y/J) button.
Hold down
3. Release the Stop (H) button when “MC-DV600**” appears on
the display.
4. Release the Play/Pause (y/J) button.
5. Press the Stop (H) button.