Teac MCDV600 Stereo System User Manual


 
13
After all connections are complete, connect the power cord’s plug to the AC wall socket.
< Read the instructions of each component you intend to use with this unit.
< Be sure to connect each plug securely. To prevent hum and noise, do not bundle the connection cords.
E
Digital audio output terminal
Digital audio from DVD-Video, CD and video CD is output from
this terminal.
Connect an amplifiers including a decoder, or digital audio
devices such as CD recorders, etc. to this terminal using
commercially-available coaxial digital audio cable (TOS).
< Select “ALL” or “PCM only” in the DIGITAL AUDIO SETUP (DIGITAL
OUTPUT) (page 35).
F
AUX 1/LINE OUT jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect a cassette tape deck etc. to these jacks using
commercially-available RCA cables.
Make sure to connect:
White plug
e White jack (L: left channel)
Red plug
e Red jack (R: right channel)
G
Power cord
After all other connections have been made, connect the AC
power cord into the wall socket. Ensure that your AC voltage
corresponds to the voltage marked on the rear panel of the unit.
Consult a qualified electrician if you are in doubt.
< If you are not going to use the unit for some time, disconnect the
power cord from the wall socket.