Filter
Top Products
12 TASCAM CD-RW901
Display
!
SD F G HJ
# ^ & * ( ) W
T
Y
U
I
O
P
Q$@
A
%
E
R
This display shows various types of operation informa-
tion, including CD disc information, deck operation
modes, and menu status.
!TOC The TOC indicator lights up red when a loaded
disc contains TOC (Table of Contents) data.
@Track number display During playback or selec-
tion, the track number is displayed.
When Incremental playback is on, and when in play-
back or playback ready mode, the TRACK indicator
blinks.
#MP3 The MP3 indicator lights when a MP3 disc is in
the deck.
$Counter display Depending on the time display
mode, TOTAL or REMAIN are lit. The counter display
indication are in minutes (three digits) and seconds
(two digits).
%KEY The KEY indicator lights when Key Control is
on.
^PITCH The PITCH indicator lights when Pitch
Control is on.
&A.CUE The A.CUE indicator lights when Auto Cue is
on.
*A.READY The A.READY indicator lights when Auto
Ready is on.
(A. TRACK The A.TRACK indicator lights when the Auto
Track is on.
)Meter This displays the playback level, as well as
the input level of the source device.
QA-B The A-B indicator lights when the A-B repeat
function is on.
Also, this flashes until a “B-point” is entered.
WREPEAT The REPEAT indicator lights when the
Repeat function is on.
ESYNC The SYNC indicator lights up when SYNC is
on.
RREC When the SRC function is on, this lights dur-
ing recording, or in recording standby mode.
When the SRC function is off,
this flashes during
recording, or in recording standby mode.
b ATT control right and left Use a small Phillips
screwdriver with these attenuators to reduce the out-
put level from either the right or left balanced analog
output. The adjustable level is up to -10 dB.
n ANALOG OUT (BALANCED) (L, R) These XLR
connectors output analog audio signals at +4 dBu to
suitably-equipped units.
The wirings are: 1=grounding, 2=hot, 3=cold.
m
CONTROL I/O (parallel) terminal Use this 15-pin
D-sub connector to connect the unit to suitably-
equipped units, allowing control of the CD-RW901.
The pinouts of this connector are described (see
Connections” on page 9).
,
CONTROL I/O (RS-232C) terminal RS-232C com-
patible serial control from an external PC can be
performed.
.
REMOTE IN terminal Connects the supplied
RC-RW901 remote control unit.
/
AC IN jack Connects the power cable supplied.
2 − Features of the CD-RW901