Filter
Top Products
TASCAM CD-RW901 19
Playback modes
There are four different playback modes. The selected
mode will be indicated on the left of the display.
Continuous playback mode (default setting): no indi-
cation lamp
Single playback mode: SINGLE is lit
Program playback mode: PROGRAM red lamp is lit
Random playback mode: RANDOM red lamp is lit
The playback mode can be selected using the P.MODE
key on the remote control unit. Pressing the key chang-
es the playback mode on the display in the following
order:
Continue
®
Single
®
Program
®
Random
You can also select the playback mode using the PLAY
MODE option in the PLAY sub-menu (see “Operation
basics” on page 16). Turning the MULTI JOG dial
clockwise changes the playback mode shown on the
display in the following order:
Mode>Cont
®
Mode>Single
®
Mode>Program
®
Mode>Random
•
•
•
•
Pressing the MENU key or pushing the MULTI JOG
dial returns to normal mode from the menu mode.
While the mode can be changed from any playback
mode, the explanation in this manual will assume the
user is starting from the Continuous mode.
NOTE
The selected playback mode remains after power
is turned off. However, the program playback mode
will be cleared to “Continuous” mode when the
power is turned off.
Continuous playback
Programing is cancelled, and playback continues in the
normal order.
1. When stopped, set the mode to display
Continue or
Mode>Cont.
2. Press the
PLAY key to begin playback in order of
the track number.
Index search
This Index search function allows you to search indexes
within a track that were assigned during recording (see
“Incrementing index numbers automatically” on page
29).
Use the INDEX option in the SYSTEM sub-menu (see
“Operation basics” on page 16) to set the function on.
The MULTI JOG dial or MENU (+/-) key on the remote
control can be used to select on or off.
Index XX appears on the display.
Select a track you want to assign indexes to, and put the
unit in playback or playback ready mode.
Use the ˚/¥ or ∆/˙ key to search through the
indexes. The unit locates to the index selected, and
starts playback at that point, or goes into playback
ready mode after moving to that point.
Operation variations
Even if the final “seconds” time value is not input, play-
back will begin from the selected “minutes” time after
pressing the ENTER or PLAY key. Or, if you press the
READY key, the unit will enter the playback standby
mode at the selected point.
Specifying a track number only
After inputting the track number, press the ENTER
or PLAY key to begin playback of that track, or the
READY key to cue the track and enter playback standby
mode.
NOTE
Instead of inputting the three-digit track number,
you can input only the desired track number.
Example: To specify track 3, input only “3”.
ª
Specifying to the minute
After inputting the three-digit track number and the
number of minutes after the start of the track, press the
ENTER or PLAY key to begin playback of that track,
or the READY key to cue the track and enter playback
standby mode.
Example: To specify 1 min 00 sec from the start of
track 2, input “002 001”
NOTE
Following the above example, if “0021” is input, the
same position will be located.standby mode.
4 − Playback operations