Filter
Top Products
13
EN
1
Minimize the volume.
Use the VOLUME knob or the remote control VOLUME
buttons to minimize the volume.
−∞ dB: Minimum volume
0 dB: Maximum volume
2
Set the POWER switch to ON.
3
Turn the INPUT SELECTOR knob to select
the input source.
The indicator for the selected source lights.
Basic operation
o
If digital audio signals input through OPT1, OPT2 or
COAX inputs are in a format other than PCM (e.g.
Dolby Digital, DTS, AAC), the input indicator will
blink. Since this unit only supports the input of PCM
format signals, confirm that the digital output of
the connected equipment is in PCM format. Some
devices convert signals into PCM format before out-
put. See the operation manuals for the connected
devices.
o
Before connecting a computer and selecting USB,
install the dedicated driver on the computer (see p.
14). Playback from a computer that does not have
this driver installed is not possible.
4
Operate the playback device.
Refer to the operation manual of that device.
5
Adjust the volume.
−∞ dB: Minimum volume
0 dB: Maximum volume
Start playback on the source and use the VOLUME
knob or remote control VOLUME buttons to adjust the
volume to its optimal level.