Filter
Top Products
15
THE TC ICON EDITOR
Basic Operation
The Icon Link key in the upper left corner
allows you to navigate between two main
pages/modes.
Fig 1 - Setup/Select page
Via the “overall” Select & Setup pages you
access overall settings and choices like:
• Selection of which connected unit to operate.
• Enable devices to network.
• TC Icon settings such as display and Fader-
appearance.
On the Select page illustrated above (Fig 1) all
connected units will appear. Press one of the
units indicated on that page.
Auto page
This page is redundant when operating a P2.
Fig 2 - Operating pages
Press the Icon Link key in the upper left corner
to select these pages.
These pages are relevant to one specific unit.
Library pages handle operations such as preset
Recall/Store and Delete.
System p
ages handle overall Clock Settings,
I/O settings and network settings.
Engine p
ages is where you control all algorithm
specific processing parameters.
Renaming presets
All user presets can easily be renamed.
Click on the CURRENT ENGINE NAME key on
the Store page and a keyboard display will
open.
The preset is not stored by entering the
name and pressing ENTER.
To actually store a preset the STORE key
must be pressed on the Store page.
Link
The LINK key allows you to assign any
algorithm parameter to any of the 6 Faders.
Thereby you are not limited to operate only the
parameters visible on the current page. You can
have e.g. In gain parameter from the Main page
on Fader 1 and the Loudness Level trim from
the Loudness page on Fader 2 etc.
To assign a parameter
• Press the LINK key.
• Select the Fader you wish to link a parameter
to, by pressing the field just above the fader.
• Press the parameter you wish to link to the
selected fader.