Filter
Top Products
8 TASCAM MD-02/MD-02B
Front panel
(see “Changing the time and character information
display” on page 20).
During title input, press this key to cycle through
character types: lower case letters, upper case letters
and katakana (see “Title input method” on page 26).
TIME key
Press this key to change the time mode shown on the
display (see “Changing the time and character informa-
tion display” on page 20).
During playback: track elapsed time, track remaining
time
During recording: recording elapsed time, disc remain-
ing time
The time mode setting is retained even when the power
is turned OFF.
Remote sensor
When using the included wireless remote control
(RC-MD02), point it toward this sensor.
Display
This shows information about discs, tracks, deck
operation mode, menus and other items (see “Display”
on page 11).
POWER ON PLAY switch
Use to turn power on play on and off. When set to ON,
playback will begin automatically when the power
is turned on if a disc is loaded (see “Using power on
play” on page 19).
INPUT (L, R) knobs
Use to adjust the analog input levels (see “Adjusting the
recording level” on page 23). Independent adjustment
of both left and right signals is possible.
PHONES level knob
Use to adjust the headphones output level.
POWER switch
Turns the power ON and OFF.
CAUTION
Minimize the volume of connected devices before
turning the power ON. Failure to do so could cause
sudden loud noises, resulting in hearing damage, for
example.
MD slot
Insert MD discs for recording or playback here.
Insert in the direction of the arrow with the label side
up.
MENU key
Press to turn the menu mode ON and OFF (see “ 4 –
Menu Operation” on page 16).
EJECT key
Press to eject MD discs.
REPEAT key
Press to change the repeat playback mode (see “Repeat
playback” on page 19).
The repeat mode setting is retained even when the
power is turned OFF.
NOTE
If the unit is in single repeat mode when the STOP
•
key is pressed, the mode changes to all repeat.
If the unit is in single repeat mode when the power is
•
turned OFF, the mode changes to all repeat when the
power is turned ON again.
ESCAPE key
When in menu mode, press this key to return to the
previous menu (see “ 4–Menu Operation” on page 16).
DISPLAY key
When stopped, press this key to show the current disc
title on the display. During playback and playback
standby, press this key to show the current track title
2 − Names and Functions of Parts