Tascam GA-100CD Stereo Amplifier User Manual


 
2 – Part names and functions
10 TASCAM GA-100CD
o OUTPUT key
Press this key to select the effects signal output –
the main speaker, the sub-speaker pair or all three
speakers. Each time you press this key, the output
destination setting changes and one or both of the
indicators (
MAIN, SUB) lights.
p Effect Knob 1
Adjust the first parameter of the selected effect. The
panel shows each effect’s adjustable parameters.
(See “Using effects” on page 16.)
a Effect Knob 2
Adjust the second parameter of the selected effect.
The panel shows each effect’s adjustable parameters.
(See “Using effects” on page 16.)
s Effect Knob 3
Adjust the third parameter of the selected effect.
The panel shows each effect’s adjustable parameters.
(See “Using effects” on page 16.)
Reverb section
Use to set the built-in reverb.
d REVERB knob
Adjust the reverb signal output level.
f SOURCE key
Select the reverb input signal.
Choose
DIRECT to apply reverb to the guitar signal
as it comes in the
INPUT jack. Select EFFECT to
apply reverb to the effects output signal. You can
also select both to apply reverb to the dry guitar
signal and the effect output.
g OUTPUT key
Press OUTPUT to choose the reverb signal output
destination – the main speaker, the sub-speaker pair
or all three speakers. One or both of the indicators
(MAIN, SUB) lights to reflect the selection.
CD Trainer
In addition to standard CD player functions, the CD
Trainer also has a tuner, a metronome, an oscillator and
other features.
h CD player cover
Lightly press the ø mark at the front of the cover to
open the player.
j CD Trainer LCD
Shows the CD Trainer status.
k TIME/ESC key
When a time is displayed, press this key to change
the time display mode.
When using a menu, press this key to return to the
time display.
l LOOP I/O key
Use for loop playback.
Press this key to set the loop IN point (starting
point) for the currently playing or paused CD. Press
this key again to set the OUT point (ending point)
and start loop playback automatically.
When IN and OUT points are set, press and hold
this key to turn loop playback between the IN and
OUT points ON and OFF.
When IN and OUT points are not set, press and hold
this key to turn single track or all track repeat ON
and OFF. (See “Repeat playback of a selected loop”
and “All track or single track repeat playback” on
page 18.)
h
j
k
l
z
x
;
c
v
b
n
m
,
.