Filter
Top Products
… Do not operate this deck when the temperature is out-
side the operating range of 5˚C to 35˚C. To prevent
malfunctions, do not install this deck anywhere where
it could be exposed to dust or subject to high humidity.
… Do not apply excessive force. This could damage the
internal circuitry or the cabinet.
… Use a soft cloth (such as a silicone cloth) to clean the
cabinet. If the unit is very dirty, wipe the dirt off with
a cloth dipped in diluted detergent. Do not use solvents
such as thinner and benzine as these can melt plastic or
coated surfaces and fade characters inscribed on the
panel.
… Because of improvements in design and specifications,
the product shown in illustrations in this manual may
differ from the actual product.
55
Section 1 : Introduction
1-1. Configuration
This deck consists of the following.
1.DA-302 main unit
2.Accessories
Mount screw kit
RC-D302 remote control unit
Owner's manual
1-2. Memory backup
AUTO ID mode, AUTO ID detection level, memo point
and menu setting data are all retained in the DA-302’s
internal memory even when the power is turned off.
1-4. Condensation
When you move the deck from a cold place to a warm
place or use it after a sudden temperature change, conden-
sation may occur. If this happens, leave the power on, but
do not operate the deck. After one or two hours, turn the
power off and then on again.
1-3. Installation and operation precautions
Rack mounting
Install this deck with the provided mount screw kit as
illustrated.
Note:
When mounting this deck in a rack, do not reinstall the
mount screws after removing the deck’s feet or you may
damage PCBs or other internal components. Handle the
removed feet carefully.
AC POWER CORD CONNECTION
CAUTION :
TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
CORDON DE CONNEXION CA
ATTENTION :
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRO-
DUIRE LA LAME LA PLUS LARGE DE LA FICHE
DANS LA BORNE CORRESPONDANTE DE LA
PRISE ET POUSSER JUSQU' AU FOND.
For CANADA