Filter
Top Products
21
Section 7 : Recording/editing of subcode data
5
When the PLAY key is pressed, playback takes place
for about 3 seconds from the captured ABS time.
Then, the Play-Pause mode is engaged.
·In this status, press the UP and DOWN keys simul-
taneously or press the CLEAR key on the remote
control unit to restore the condition in step 3.
6
Each time the UP key or DOWN key is pressed in the
Play-Pause mode, the captured ABS time can be
changed by +5 frames or -5 frames (up to ±2 seconds).
Posi1 0¡13™45£09
fi
DOWN key
Posi1 0¡13™45£14
ı
UP key
Posi1 0¡13™45£19
7
Repeat steps 5 and 6 to set the desired point, then
press the EXECUTE key. The Start ID is recorded
from that point.
7.2.3 Erasing the Start ID
1
Select the deck with the SELECT 1/2.
2
Press the ID MODE key so that "START ERASE"
lights in the display.
3
In the Stop or Play mode, press the EXECUTE key.
The tape is rewound to the previous Start ID and this
Start ID is erased while it is being played.
During erasing, the "START ERASE" blinks and
when erasing is complete, the normal playback is
restored.
Skip IDs are recorded to enable skip playback (úp.18).
7-3-1. Recording the Skip ID
… Recording on the fly
1
Select the deck with the SELECT 1/2 key.
2
Press the ID MODE key so that the "SKIP WRT" lights
on the display.
3
During recording or playback, press the EXECUTE
key at the point where you want to record the Skip ID.
The "SKIP WRT" blinks and the Skip ID is recorded
for one second from that point.
·When the COMMON MODE switch is set to
"1&2", the Skip ID is recorded on tapes in both
Deck 1 and Deck 2 regardless of the setting of the
SELECT 1/2 key.
… Recording with the menu
1
Select the deck with the SELECT 1/2 key.
2
Press the ID MODE key so that the "SKIP WRT" lights
on the display.
3
Press the MENU key to show the following menu in
the time display.
Posi1 –¡––™––£––
4
Press the RESET key during playback to capture the
current ABS time. The time is shown in hours, min-
utes, seconds and frames in the time display. Then, the
deck enters the Play-Pause mode.
Posi1 0¡13™45£14
5
Press the PLAY key to play back the tape from the cap-
tured ABS time for about 3 seconds. Then the Play-
Pause mode is engaged.
·In this status, press the UP and DOWN keys simul-
taneously or press the CLEAR key on the remote
control unit to restore the condition in step 3.
6
Each time the UP or DOWN key is pressed in the Play-
Pause mode, the captured ABS time is changed by +5
or -5 frames (up to ±2 seconds).
Posi1 0¡13™45£09
fi
DOWN key
Posi1 0¡13™45£14
ı
UP key
Posi1 0¡13™45£19
7-3. Skip ID