Filter
Top Products
27
Section 9 : Using more than one DA-302
One source can be recorded on more than one deck at the
same time.
1
Connect DA-302s as shown in the figure in "9.1
Continuous recording with more than one DA-302".
·In this case, the connection marked with ** is not
necessary.
2
Set the first DA-302 to Master Deck and the other DA-
302s to Slave Deck. Set decks to master/slave deck
with "Control" in the menu. (úp.28)
3
For all connected DA-302s, perform procedures 2 to 3
in "5.3 Dual recording".
4
Press the REW key on Deck 1 of the master deck to
rewind the tapes in all decks to the beginning.
5
When the Record mode is engaged on Deck 1 on the
master deck, all decks automatically enter the Record
mode.
6
To stop recording, press the STOP key on Deck 1 of
the master deck.
… If the COMMON MODE switch is set to "1&2", when
the STOP key, PLAY key, PAUSE key, RECORD key, F
FWD key, REW key or REC MUTE key on Deck 1 or
Deck 2 of the master deck is pressed, the command is
output to all slave decks.
9-2. Duplicating
Continuous playback on more than one DA-302 is possi-
ble beginning with the first deck, then the second deck,
and so on.
1
Connect DA-302s as shown in the figure in "9.1
Continuous recording with more than one DA-302".
2
Set the first DA-302 to Master Deck and the other DA-
302s to Slave Deck. Set decks to master/slave deck
with "Control" in the menu. (úP.28)
3
For all connected DA-302s, perform procedures 1 to 2
in the "6.2 Continuous playback".
4
Press the REW key on Deck 1 in the master deck to
rewind the tapes in Deck 1 in the master deck and the
slave decks to the beginning.
·Only the REW key on Deck 1 of the master deck
controls the slave decks.
5
Press the REW key on Deck 2 in the master deck to
rewind the tape in Deck 2 in the master deck to the
beginning.
6
Press the PLAY key on Deck 1 of the master deck to
start playback.
When Deck 1 reaches the time set with "Seqtime",
Deck 2 starts playback.
When Deck 2 reaches the time set with ''Seqtime'',
Deck 1 in the second deck receives the command from
the EXT CONTROL IN connector and starts playback.
This process continues from deck to deck, enabling
continuous playback.
·This procedure is almost identical to that in "9.1
Continuous recording with more than one DA-302".
(The difference being that one is for playback and
the other is for recording.) For more details on
operation, refer to the example in "9.1 Continuous
recording with more than one DA-302".
7
To end the operation in the middle, press the STOP key
of the deck which is playing back.
… Each deck which starts playback rewinds the tape
automatically to the beginning either 3 minutes after
the time set with "Seqtime" or when the tape end is
reached.
9-3. Continuous playback with more than
one DA-302