Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
TASCAM 202MKIV 23
4 − Recording
TASCAM 202MKIV 23
Editing during dubbing (only at normal speed)
You can prevent unwanted songs or unnecessarily
long blanks from being dubbed, or you can create
blanks between songs.
1. At the desired point during dubbing, press the
PAUSE key on the TAPE 2 deck. The TAPE 2
deck only enters the pause mode, allowing you
to let unwanted songs go by.
To create a 4-second blank between songs, press
the REC MUTE key on the TAPE 2 deck. The
TAPE 2 deck temporarily stops after recording no
signal for 4 seconds.
The TAPE 1 deck continues playback when the
TAPE 2 deck is in pause mode.
2. To resume dubbing, press the
PAUSE key on
the TAPE 2 deck.
When you use this dubbing function and a shorter
tape reaches the end of side “A”, it momentarily stops
until the other tape reaches the end of side “A”. Then
both tapes automatically switch over to side “B” and
recording and playback re-start simultaneously.
If TAPE 1 is shorter than TAPE 2
When TAPE 1 reaches the end of side “A”, TAPE 1
stops and TAPE 2 enters the “blank recording” mode.
When TAPE 2 reaches the end, both TAPE 1 and ll are
reversed simultaneously. TAPE l starts reverse play
and TAPE 2 resumes recording.
When TAPE 1 reaches the end of side “B”, both TAPE
1 and ll stop simultaneously.
If TAPE 1 is longer than TAPE 2
When TAPE 2 reaches the end of side “A”, TAPE 1l
enters the record-pause mode, while TAPE 1 contin-
ues playback.
When TAPE 1 reaches the end, TAPE 1 starts reverse
play and TAPE 2 starts recording.
When TAPE 1l reaches the end of side “B”, both
TAPE 1 and ll stop simultaneously.
1. Insert a cassette tape for playback into the
TAPE 1 compartment and a cassette tape for
recording into the TAPE 2 compartment.
Side “A” facing you
2. Set the REV MODE switch to the two-way (Ë)
position.
3. Check the recording direction of both decks.
If the reverse direction indicator (˙) lights on
the display, press the PAUSE key followed by the
forward play key (¥). Then, be sure to press the
STOP key (ª) to get out of the pause mode.
Synchro reverse dubbing (from TAPE 1 to TAPE 2)