Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
TASCAM 202MKIV 21
4 − Recording
TASCAM 202MKIV 21
4. Check the recording direction.
If an indicator is lit which points in the direction
opposite to the one desired, change the direction
by pressing the opposite direction play key (˙ or
¥).
NOTE
Be careful not to press play key whose arrow
points in the same direction as the indicator.
Doing so will start recording.
Recording is done in this order:
TAPE 1 Side “A”
≈
Side “B”
≈
TAPE 2 Side “A”
≈
Side “B”
You can start recording from side “B” of TAPE
1. But if you do so, side “A” of this tape is not
recorded: when recording reaches the end of side
“B”, the TAPE 2 deck starts recording.
NOTE
The TAPE 2 deck always starts recording from
side “A”.
5
Start recording.
Recording starts when you press the PAUSE
key or the play key whose arrow points in the
same direction as the indicator on the TAPE 1
deck.
When recording is nished on the TAPE 1 deck,
the TAPE 2 deck automatically starts recording.
NOTE
The transition from TAPE 1 to TAPE 2 takes sev-
eral seconds.
A. To stop recording
Press the
STOP key (ª) of the deck which is
currently recording.
Parallel recording
This function allows you to record the same material
simultaneously on both TAPE 1 and TAPE 2.
Load tapes into both decks and press the
PARALLEL REC key to start recording.
Before starting recording, check and correct the fol-
lowing by performing steps 1 – 7 on page 16 such as
Record direction, Reverse mode setting, Dolby NR
setting, Recording level, etc.
When everything is ready, get back into stop mode if
the deck is in another mode.
During parallel recording, the PARALLEL indicator is lit
on the display.
During parallel recording, only the following keys
work:
TAEP I deck:
STOP
TAPE 2 deck: PAUSE, REC MUTE, STOP
Pressing the STOP key (ª) on either deck stops both
tapes at once.