Tascam CD-DJ1 CD Player User Manual


 
14 TASCAM CD-DJ1
Basic operation
The following procedures explain use with the fac-
tory settings (playback mode is set to continuous
playback of all tracks and Auto Cue is on).
WARNING
When using headphones, be careful not to turn up
the volume too much. Listening at a high volume
over a long time can damage hearing.
1. Turn the power on by pushing the power
switch. appears on the display.
2. Open the CD cover and place a disc label-side up.
3. Close the CD cover. The total number of
tracks and the total playback time appears on
the display.
4. To prevent accidental CD cover opening, pull
down the lock lever until the word LOCK appears.
5. Press the PLAY/PAUSE key. Playback begins
from track 1.
To Pause playback, press the PLAY/PAUSE
key. Press the PLAY/PAUSE key again to re-
start playback.
Use the SKIP keys to select specic tracks for
playback.
To monitor the sound with headphones, plug
the headphone cord into the PHONES OUT
jack and adjust the level with the PHONES
volume dial.
NOTE
The CD-DJ1 does not have a STOP key.
4- Playback operations
Playback modes
This unit has four playback modes. The display
shows the currently selected mode. Press the PLAY
MODE key to change the playback mode.
Continuous playback of all tracks: (no indication)
Single-track playback: SINGLE
All track repeat playback: ALL REPEAT
Single-track repeat playback: SGL.REPEAT
Discs for playback
The CD-DJ1 can play these types of discs.
Commercial audio CDs and CD-DA format
CD-Rs and CD-RWs.
CD-Rs and CD-RWs discs with MP3 files record-
ed in CD-ROM format (see “MP3 playback” on
page 20).
However, the CD-DJ1 may not be able to play some
CD-Rs and CD-RWs due to disc quality or record-
ing conditions. If the error message
appears, remove and clean or replace the loaded disc.
This chapter explains basic CD player functions.
Unless specifically noted, these instructions are for
using audio CDs.
For playback of CDs with MP3 files, see “MP3 play-
back” on page 20.
Track selection
Use the SKIP (µ/≤) keys to select tracks.
Press the µ SKIP key once when the CD is playing
or paused to jump to the start of the currently select-
ed track. Press the µ SKIP key again to jump to the
start of the previous track.
Pressing a SKIP key during playback starts playing
the newly selected track immediately.
Pressing a SKIP key when the CD is paused sets the
pause position to the start of the selected track (if
Auto Cue is on, the pause position is set to the first
moment of sound on the selected track).