Sunfire XTATM265230 Speaker User Manual


 
14
User's Manual
User's Manual
User's Manual
User's Manual
System Congurations
The following pages show some typical
connections that you might make in your
installation. They show how the inputs
and outputs of the Sunre Subwoofer
are con nected to your preamplier or
receiver.
If your preamplier has a
subwoofer output (often labeled
LFE for Low Frequency Ef-
fects), it can be connected to the
subwoofer’s left or right input as
shown. This is the simplest and
recommended connection. A re-
ceiver with a sub/LFE output can
be connected in the same way.
The subwoofer will play the low
frequency range and the
other speakers will play
the frequency range
delivered to them by
your amplier.
If you have a Home
Theater preamplier, it
may have an inde-
pendent subwoofer
volume control. Make
sure this is correctly
adjusted, and that the
Sunre Subwoofer’s
crossover frequency is
set to 100 Hz. This is
by no means an iron-
clad rule, rather it is
a good starting point.
(See the crossover fre-
quency control details
on page 6 and adjustments on page 18).
You can set the subwoofer’s level control
to 0 dB, and then use the preamplier’s
subwoofer level control for normal and
routine adjustments.
Connections to a preamplier’s subwoofer output