Filter
Top Products
5
©1999 - INLINE, INC. IN3264 / IN3268 OPERATION MANUAL - REV 1.3 01/04/01
IN3268 BOTTOM BOARD DEFAULT
LED COIL
To allow a loop-output, the J2, J3 and J4 pins must be open on both the top and the bottom boards. Again,
the outputs will be overdriven if there is no local monitor connected to the input when the termination is
disabled. This may cause serious problems to the display device.
Warning: Jumpers should only be adjusted by qualified technicians! An
improper setting may lead to incorrect operation and could even result in
severe damage to the computer video port or the monitor.
J8 J2
J9
J10 J3
J11
J12 J4
J13