Filter
Top Products
2
IN3264 / IN3268 OPERATION MANUAL - REV. 1.3 01/04/01 ©1999 INLINE, INC.
INPUT / OUTPUT COMPATIBILITY
VGA / SVGA / XGA Compatibility - The unit features 15-pin HD VGA-type connectors for input
and outputs. The units will directly connect to VGA video cards and display devices using the IN8000
Series of VGA extension cables, available in a variety of lengths from 3’ to 100’. Longer lengths are
available by custom order.
MAC / SUN / SGI / Workstation Compatibility - While the IN3264 / IN3268 is primarily designed
for VGA-type video cards and monitors, this distribution amplifier actually has 6 discrete amplification
paths and is capable of amplifying analog video signals in a variety of sync formats including RGBHV,
RGBS, RGsB, and RGBHVS. The IN3264 / IN3268 can connect to MAC, SUN, SGI and other high-
resolution workstations and monitors by using input and output adapter cables (see list on page 7).
VGA, SVGA, XGA, SUN, SGI and other workstation video cards operate in
several different modes encompassing a wide range of resolutions and
horizontal and vertical scan rates. The IN3264 / IN3268 is not
a scan
converter and the display devices attached to the outputs must be compatible
with the resolution, horizontal scan rate and vertical refresh rate output of
computer video card. Please check the documentation for both the computer
video card and the data projection device in order to ensure compatibility.
Installation
This section offers step-by-step instructions for installing the IN3264 / IN3268.
1. Turn the computer and computer monitor off. Disconnect the computer monitor (if present) from the
video output port on the computer.
2. Connect an input cable between the computer video port and the IN3264 / IN3268 input using the
appropriate cable as indicated in the chart on Page 7.
3. Connect the local computer monitor (if present) to Output #1 on the IN3264 / IN3268 distribution
amplifier. VGA local monitors can be connected directly to the output. Other types of local monitors
are connected using the appropriate adapter / extension output as indicated in the chart on Page 7. If no
local monitor is connected to Output #1, you can emulate a VGA color monitor / MAC 13" RGB
monitor using the dip switch located on the bottom of the unit.
4. Connect output devices (monitors, data projectors, etc.) to the other IN3264 / IN3268 output
connectors. Devices may be connected directly to the outputs, or you may use the appropriate adapter
/ extension output cables as indicated in the chart on Page 7. For best results, high-resolution coaxial
cables are recommended for all output connections. Note: All unused outputs are self-terminating and
do not require a termination plug.