Sun Microsystems DVC-3 Stereo Receiver User Manual


 
Model DVC-3 Digital Video Coach
8
The same 2 patterns are also useful for Video-over-UTP Category
cable both for the high-frequency loss compensation (above
paragraph), but also for Skew Compensation for those devices that
give you this flexibility. The right and left edges of the RGB bars
should vertically line-up. Again, this pattern gives you a
convenient means for making this adjustment.
Operation Summary
To change the resolution being produced press the OUTPUT
MODE button repeatedly. The output screen has an OSD to
indicate the resolution and refresh rate settings
NOTE: It is possible to set the output resolution to one that
your monitor does not support. In this case you my not get a
screen. You can either keep pressing the OUTPUT MODE
button as it eventually goes through all the available outputs
in a circular fashion, or use 2-button “Quick Select”
combination to jump to a specific output immediately.
To change pattern press the + or – keys.
To get analog high res. component video output at the HD15
connector (instead of VGA), slide the switch to YPbPr and
press the 480p “Quick Select”. The LED will turn on to
indicate that there is a valid component output signal present.
NOTE: If the LED is not on that means you are not getting a
proper analog component output! Either the output MODE is
not at one of the HDTV settings, or the slide switch is not in
correct position.
NOTE: The DVI connector outputs all available resolutions
(both PC and HDTV)
When you change the output, the DVC-3 memorizes your
settings after 8 seconds and the next time the unit is tuned on
it will recall the memorized settings.