Filter
Top Products
9
•
SWITCHING
THE UNIT ON/OFF
Switch on the unit by pressing any
button (except OPEN/CLOSE button
(7)). When system is on, press
button
(9) to turn off the unit.
• FACEPLATE RELEASE
Press OPEN/CLOSE button (7) to slide
down the removable faceplate down.
• SOUND ADJUSTMENT
Press PUSH SEL button (10) to select
the desired adjustment mode.
The adjustment mode will change in
the following order:
By rotating the volume knob (10)
clockwise or counter-clockwise, it is
possible to adjust the desired sound
quality.
• LOUDNESS
Press BND/LOU button (13) for
several seconds to reinforce the bass
output. Press it for several seconds
again to release this function.
• SET THE CLOCK
Press the DSP button (15), the clock
is displayed on the LCD display. Then
hold down the button until the clock
flashes. Then press the
button (17)
to change hours or
button (16) to
change minutes.
• MUTE
Press MUT button (3) to mute the
volume instantly. If any button is pressed
while in the mute mode, the mute
function is released.
• EQUALIZATION
Press EQ button (19) to turn on
equalization function and to select
desired audio mode. There are four
kinds of mode as below:
• LIQUID CRYSTAL DISPLAY
Shows current frequency and activated
functions on the display (8).
• FLASHING LED
If the front panel does not install in the
main unit, the LED (4) will be flashing.
• REMOTE SENSOR
Point the remote control handset to
the remote sensor IR (11). Press the
function keys on the handset to control
the system.
• RESET FUNCTION
RESET button (12) must be activated
with either a ball point pen or thin
metal object. The RESET button (12)
is to be activated for the following
reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not
operate.
- Error symbol on the display.
Note: If you press RESET button (12) and
the unit still does not work, please use a
cotton swab soaked in isopropyl alcohol to
clean the socket on the back of the front
panel.
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MOD button (6) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.
• SELECTING THE FREQUENCY
BAND
In radio mode, press BND/LOU button
(13) to select the desired band.
The reception band will change in the
following order:
• SELECTING STATION
Press
button (17) or button (16)
shortly to activate automatic seek
function. Press for several seconds until
“MANUAL” appears on the display, the
manual tuning mode is selected. If
buttons (16) and button (17) have
not been pressed for serveral seconds,
the unit returns to seek tuning mode
and “AUTO” appears on the display.
• LOCAL/DISTANT
Press LOC button (2) to select
between local and distant stations.
Local setting is for reception of strong
stations and distant setting is for
reception of weaker setting. This
function is effect during AUTO SEEK
operation.
• AUTOMATIC MEMORY
STORING & PROGRAM SCANNING
- Automatic Memory Storing
Press AMS button (18) for several
seconds, the radio searches from the
current frequency and checks the
signal strength until one cycle search
is finished. Then the 6 strongest
OPERATION
FM1 FM2 FM3 AM
VOL BAS TRB BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
FLAT CLASSICS POP M ROCK M DSP OFF