Filter
Top Products
1-2. Main Unit (Rear Panel)
5. OUTPUT jacks (RCA, unbalanced)
RCA connectors providing line level output signals, one set each for discs 1 and 2.
Maximum output level is +6dBV (2Vrms)
6. DIGITAL OUTPUT jacks (COAXIAL, S/PDIF)
Coaxial connectors provide S/PDIF digital output signals. These connectors can output the 44.1KHz
digital signals constantly even if pitch control is activated.
7. FADER START jacks
The C.504 can be controlled using the external Fader start command through these jacks. Connect
the mixer which supports the fader start function with appropriate 1/8” Fader Start cable as well as
audio signal. (TIP: Start, GND: back cue)
NOTE: When using the fader start function, connect the audio signal with the mixer as well. Also,
two 1/8” fader start cables are supplied in this unit.
8. AUX connectors (not included)
This jack is for future expansion capabilities.
9. REMOTE connector
Use this included connector to connect the remote controller to the main unit.
W
ARNNING
* DO NOT use any cable except the cable supplied with the C.504.
* Connect the cable in the way shown on the illustration on the rear panel of the C.504. If you con-
nect the cable in any other way, you may damage the C.504.