Filter
Top Products
15
During AF search, PI stations and non-RDS (Radio Data Station) stations with strong signal will
be masked, in the latter case, the non-RDS stations may cause interference, resulting the real
AF to be masked due to the misjudgment of the radio under interference. Press VOL+/VOL-
buttons to select the desired mode: MASK DPI and MASK ALL.
- MASK DPI: To mask only the AF with different PI.
MASK ALL: To mask both PI and strong signal non-RDS station.
TA VOL
Choose the TA volume level.
RETUNE mode
To determine the initial time of automatic TA (Traffic Announcement) search. There are 2
modes: RETUNE L and RETUNE L.
- RETUNE L: 90 seconds.
- RETUNE S: 30 seconds.
Note: Retune mode is active for TA SEEK mode only.
EQ MODE:
The car audio device is equipped with 4 preset equalization modes. After entering this mode
select the EQ mode as follows: DSP OFF, DSP POP, DSP ROCK, DSP CLAS, DSP FLAT. When
using preset EQ modes you will not have access to Bass and Treble settings.
LOUD ON/OFF:
Choose Loud ON or OFF.
CLOCK FORMAT:
Choose 12 of 24 hours mode
VOL LAST/ADJUST:
Choose between VOL LAST and VOL ADJ.
- VOL LAST: The unit switches on at the actual last volume level when it was last switched off.
VOL ADJ: you can pre-select a constant switch-on volume after entering into this mode. To set
the volume to a certain level, press the SEL button momentarily when V-ADJ is displayed. Then
press VOL+/VOL- buttons to adjust to certain volume level.
BEEP mode
BEEP: the unit beeps only when any allowed double button is pressed longer than 1 sec.
BEEP ON: the unit beeps when any button is pressed.