Sony TC-WE475 Cassette Player User Manual


 
18
Synchro-recording with a CD
player
By pressing SYNCHRO, you can perform
synchro-recording on your tape deck with a
Sony CD player connected to the CONTROL
A1II connector through a CONTROL A1II
cable.
1 Set the source selector on the amplifier
to CD player.
2 Load a CD into the CD player.
3 Select the play mode (CONTINUE,
SHUFFLE, or PROGRAM) of the CD
player.
4 Load a cassette into deck B.
5 Select the side(s) to be recorded on.
To record on Set DIRECTION MODE to
Only one side g
Both side s or RELAY
6 Select the side you want to start
recording from on deck B.
To record from Press
The front side H
The reverse side h
7 Press SYNCHRO.
To stop CD Synchro-recording
Press x on deck B or the CD player.
Connecting the CONTROL
A1II control system
Connect monaural (2P) mini-plug cables in
series to the CONTROL A1II jacks on the back
of each component. You can connect up to ten
CONTROL A1II compatible components in
any order. However, you can connect only one
of each type of component (i.e., 1 CD player, 1
MD deck, 1 tape deck and 1 receiver). (You
may be able to connect more than one CD
player or MD deck, depending on the model.
Refer to the operating instructions supplied
with the respective component for details.)
Example
In the CONTROL A1II control system, the
control signals flow both ways, so there is no
distinction of IN and OUT jacks. If a
component has more than one CONTROL A1II
jack, you can use either one, or connect
different components to each jack.
About the connecting cable
When a CONTROL A1II compatible
component is not supplied with a connecting
cable, use a commercially available monaural
(2P) mini-plug cable less than 2 meters (6.6
feet) long, with no resistance (such as the Sony
RK-G69HG).
Amplifier
(Receiver)
CD player MD deck
Tape deck Other component
Using the CONTROL A1II control
system (continued)