Filter
Top Products
43
GB
D:\NORM'S JOB\SONY HA\SO0086\STR-DN610_PMRF 2\GB\GB05BAS_STR-DN610-U2.fm masterpage: Right
STR-DN610
4-167-824-13(1)
Tuner Operations
4 Press and hold SHIFT, then
press the numeric buttons to
select a preset number.
You can also press PRESET + or
PRESET – to select a preset number.
5 Press and hold SHIFT, then
press ENTER.
The station is stored as the selected preset
number.
6 Repeat steps 1 to 5 to preset
another station.
1 Press TUNER repeatedly to
select the FM or AM band.
2 Press PRESET + or PRESET –
repeatedly to select the preset
station you want.
Each time you press the button, you can
select a preset station as follows:
You can also press and hold SHIFT and
then press the numeric buttons to select
the preset station you want. To enter the
selection, press and hold SHIFT, then
press ENTER.
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR
+/– on the receiver.
2 Tune in the preset station you
want to create an index name
for (page 43).
3 Press AMP MENU.
4 Press V/v repeatedly to select
“TUNER”, then press or b.
5 Press V/v repeatedly to select
“NAME IN”, then press or b.
The cursor flashes and you can select a
character.
6 Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
•You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
•To enter a blank space, press b without
selecting a character.
7 Press .
The name you entered is registered.
Note (Models of area code CEK, ECE
only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
Tuning to preset stations
Naming preset stations
1 2 345 27...
30 29 28