Filter
Top Products
36
GB
D:\NORM'S JOB\SONY HA\SO0086\STR-DN610_PMRF 2\GB\GB04CON_STR-DN610-U2.fm masterpage: Left
STR-DN610
4-167-824-13(1)
Adjusting the speaker
levels
(TEST TONE)
You can adjust the speaker levels while
listening to the test tone from your listening
position.
1 Press AMP MENU.
2 Press V/v repeatedly to select
“LEVEL”, then press or b.
3 Press V/v repeatedly to select
“T. TONE”, then press .
4 Press V/v repeatedly to select
“AUTO xxx*”.
The test tone is output from each speaker
in sequence.
* xxx represent a speaker channel.
Note
Depending on the speaker pattern setting, test
tone may not be output from all speakers even
though you select “AUTO xxx”.
5 Adjust the speaker levels using
the LEVEL menu so that the
level of the test tone sounds the
same from each speaker.
For details, see LEVEL menu (page 62).
Tips
•
To adjust the level of all speakers at the same
time, press MASTER VOL +/– (RM-AAU073
only) or
2
+/– (RM-AAU075 only). You can
also use MASTER VOLUME on the receiver.
•The adjusted value are shown on the display
during adjustment.
6 Repeat steps 1 to 4 to select
“OFF”.
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker indicator showed in the
display
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
connection and the speaker pattern match.
.
mM
>
X
x
BD DVD
SAT/
CATV
VIDEO1
VIDEO2
SA-CD/
CD
DMPORT TUNER
MENU
O
TV
HDMI 2 HDMI 3HDMI 1
AMP
MENU
,
V/v/B/b
Input
buttons
MASTER
VOL +/–/
2 +/–