Filter
Top Products
37
GB
Preparing the Receiver
1 Press AMP MENU.
2 Press V/v repeatedly to select
“<AUTO CAL>”, then press
or b.
3 Press V/v repeatedly to select
“A.CAL START”, then press .
Measurement starts in 5 seconds. A count
down is displayed.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
* The corresponding speaker indicator lights
up on the display during measurement.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1.
– Press the input buttons or turn the INPUT
SELECTOR on the receiver.
– Change the volume level.
– Press MUTING (RM-AAP049 only) or
(RM-AAP050 only).
– Press SPEAKERS on the receiver.
– Connect headphones.
2: Performing Auto Calibration
.
mM
>
Xx
DVD
VIDEO 1
HDMI 2
DMPORT
<
<
MENU
O
BD
SAT/
CATV
VIDEO 2
HDMI 3HDMI 1
SA-CD/
CD
TUNER
TV
HDMI 4
Input
buttons
?/1
MUTING/
MASTER
VOL +/–/
+/–
,
V/v/B/b
AMP
MENU
AMP
MENU/
HOME
Measurement for Display
Speaker existence TONE
Speaker gain, distance,
frequency response
T.S.P.*
Subwoofer gain and distance WOOFER*