Filter
Top Products
31
US
Getting Started
The table below shows the display when
measurement starts.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value using “SUR POS.” parameters in the
SYSTEM menu (page 42).
Tips
•The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1, input buttons or MUTING on the
remote.
– Press SPEAKERS (OFF/A/B/A+B) or turn the
INPUT SELECTOR on the receiver.
– Change the volume level.
– Press AUTO CAL again.
– Connect the headphones.
•The measurement may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2 Press RECEIVER and then
press V/v repeatedly to select
the item. Then, press .
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response
T.S.P.
Subwoofer gain and distance WOOFER
Confirming/saving the
measurement results
Measurement
result
Display Explanation
When the
measurement
process
completes
properly
SAVE Proceed to step
2.
When the
measurement
process fails
ERROR
XXXX
See “When
error codes
appear” (page
32).
Item Explanation
RETRY Performs the Auto
Calibration again.
SAVE Saves the measurement
results and exits the setting
process.
WARN CHK Displays warning
concerning the
measurement results. See
“When you select “WARN
CHK”” (page 32).
PHASE Displays the phase of each
speaker (in phase/out of
phase). See “When you
select “PHASE”” (page 33).
DISTANCE Displays the measurement
result for speaker distance.
LEVEL Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
continued