Filter
Top Products
3
US
F:\Sony SEM
HA\Revision2_DG800\JC060412_2667346121DG800_US\2667346121\US02REG_STR-DG800-
CEL.fm
masterpage: Right
STR-DG800
2-667-346-12 (1)
About This Manual
• The instructions in this manual are for model
STR-DG800. Check your model number by
looking at the lower right corner of the front panel.
In this manual, models of area code U is used for
illustration purposes unless stated otherwise. Any
difference in operation is clearly indicated in the
text, for example, “Models of area code CA only”.
• The instructions in this manual describe the
controls on the supplied remote. You can also use
the controls on the receiver if they have the same
or similar names as those on the remote.
This receiver incorporates Dolby* Digital and Pro
Logic Surround and the DTS** Digital Surround
System.
* Manufactured under license from Dolby
Laboratories.
“Dolby”, “Pro Logic”, “Surround EX”, and the
double-D symbol are trademarks of Dolby
Laboratories.
** “DTS”, “DTS-ES”, “Neo:6”, and “DTS 96/24”
are trademarks of Digital Theater Systems, Inc.
This receiver incorporates High-Definition
Multimedia Interface (HDMI
TM
) technology. HDMI,
the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC.
XM is a registered trademark of XM Satellite Radio
Inc.
About area codes
The area code of the receiver you purchased is
shown on the lower left portion of the rear panel
(see the illustration below).
Any differences in operation, according to the area
code, are clearly indicated in the text, for example,
“Models of area code AA only”.
ASSIGNABLE
(INPUT ONLY)
DVD
IN
COAXIAL
SA-CD/
CD
IN
OPTICAL
VIDEO 1
IN
TV/SAT
IN
MD/
TAPE
IN
MD/
TAPE
OUT
ASSIGNABLE
DVD
IN
TV/
SAT
IN
MONITOR OUT
SIGNAL GND
DIGITAL HDMI
XM
ANTENNA
AM
TV/SAT
AUDIO IN
VIDEO IN
S-VIDEO
IN
DVD
AUDIO IN
VIDEO IN
S-VIDEO
IN
R
L
AUDI
O
VIDE
O
V
PHONO
IN
SA-CD/CD
L
R
L
R
MULTI CH IN
OUT IN
L
R
FRONT SURROUND
L
R
SURR
BACK
IN
MD/TAPE
Area code
US01COV_STR-DG800-CEL.book Page 3 Tuesday, March 14, 2006 3:53 PM