Sony STR-DG500 Stereo Receiver User Manual


 
73
GB
F:\Sony SEM
HA\Revision5_DG500\JC060283_2662258132DG500_GB\2662258132\GB05AMP_STR-DG500-
CEL.fm
masterpage: Right
STR-DG500
2-662-258-13 (2)
Additional Information
AM tuner section
Tuning range
Intermediate frequency
450 kHz
Usable sensitivity 50 dB µ/m (at 1,000 kHz or
999 kHz)
6)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Video section
Inputs/Outputs
Video: 1 Vp-p/75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p/75 ohms
P
B/CB/B-Y: 0.7 Vp-p/
75 ohms
P
R/CR/R-Y: 0.7 Vp-p/
75 ohms
80 MHz HD Pass Through
General
Power requirements
Power consumption
Power consumption (during standby mode)
0.2 W
Dimensions (w/h/d) (Approx.)
430 × 157.5 × 316 mm
(16 7/8 × 6 2/8 × 12 4/8
inches) including
projecting parts and
controls
Mass (Approx.) 8.0 kg (17 lb 11 oz)
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
Remote commander RM-AAU005 (1)
R6 (size-AA) batteries (2)
Optimizer microphone ECM-AC2 (1)
Design and specifications are subject to
change without notice.
Area code Tuning scale
10 kHz step 9 kHz step
U, CA 530 –
1,710 kHz
6)
531 –
1,710 kHz
6)
E2 530 –
1,610 kHz
6)
531 –
1,602 kHz
6)
CEL, CEK, AU,
TW, KR, TH6, SP
– 531
1,602 kHz
AR 530 –
1,610 kHz
Area code Power requirements
U, CA 120 V AC, 60 Hz
CEL, CEK 230 V AC, 50/60 Hz
AU 240 V AC, 50 Hz
AR, KR, TH6 220 – 230 V AC,
50/60 Hz
E2 120/220/240 V AC,
50/60 Hz
TW 110 V AC, 60 Hz
SP 230 – 240 V AC,
50/60 Hz
Area code Power consumption
U, CEL, CEK, AU,
KR, AR, E2
220 W
TH6, SP 200 W
CA 300 VA
TW 500 W
For details on the area code of the
component you are using, see page 3.
GB01COV_STR-DG500-CEL.book Page 73 Thursday, March 16, 2006 12:10 PM