Filter
Top Products
58
GB
F:\Sony SEM
HA\Revision5_DG500\JC060283_2662258132DG500_GB\2662258132\GB05AMP_STR-DG500-
CEL.fm
masterpage: Left
STR-DG500
2-662-258-13 (2)
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Tune in the preset station you
want to create an index name
for (page 57).
3 Press AMP MENU.
“1-LEVEL” appears on the display.
4 Press control button V/v
repeatedly to select “4-
TUNER”.
5 Press the control button or
control button b to enter the
menu.
6 Press control button V/v
repeatedly to select “NAME IN”.
7 Press the control button or
control button b to enter the
parameter.
The cursor flashes and you can select a
character. Follow the procedure given in
“To create an index name” below.
To return to the previous display
Press control button B.
To create an index name
1 Use control button V/v/B/b to create an
index name.
Press control button V/v to select a
character, then press control button B/b to
move the cursor to the next position.
If you made a mistake
Press control button B/b until the character
you want to change flashes, then press
control button V/v to select the correct
character.
Tip
You can select the character type as follows by
pressing control button V/v.
Alphabet (upper case) t Numbers t Symbols
2 Press the control button.
The entered name is registered.
Note (Models of area code CEL, CEK
only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
Naming preset stations
123
46
78
0/10
ENTER
9
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D.
RETURN/EXIT MENU
MOVIE MUSIC
MEMORY DVD MENU
CLEAR
TOOLSDISPLAY
MUTING
TV VOL
MASTER VOL
FM MODE
D.TUNING
D.SKIP
DUAL MONO
MD/TAPE
SA-CD/CD
TUNER
AMP MENU
-
F
Gg
f
5
>10/
3
1
4-7
GB01COV_STR-DG500-CEL.book Page 58 Thursday, March 16, 2006 12:10 PM