Filter
Top Products
18
GB
Multi channel surround setup
(continued)
When placing surround speakers behind you
Note
Do not place the center speaker farther away from the
listening position than the front speakers.
Normal Speaker and Micro
Satellite Speaker
If you are using Select
Normal Speakers NORM. SP.
Micro Satellite Speakers MICRO SP.
The speaker size and the sub woofer selection
has been preset to NORM. SP. You can adjust
the speaker size and sub woofer selection when
you select NORM. SP. (pages 18–19)
To select MICRO SP., turn off the power, then
turn on again while pressing LEVEL. (To reset
to NORM. SP., do the same procedure.)
When you select MICRO SP., the speaker size
and sub woofer selection has been configurated
as follows:
Speaker Settings
FRONT SMALL
CENTER SMALL
SURROUND SMALL
SUB WOOFER YES
You cannot change the configuration if you
select MICRO SP.
Tip
The setting for Micro Satellite Speaker (MICRO SP.)
has been programmed to optimize the sound balance.
If you use Sony’s Micro Satellite Speakers, select
MICRO SP.
Caution
When you use Micro Satellite Speakers and the
speaker size is set to “LARGE”, you may not obtain
the correct soundstage. The speaker may also be
damaged at high volume position.
Specifying the speaker
parameters
1 Press SET UP.
2 Press or to select the parameter
you want to adjust.
3 Turn the jog dial to select the setting
you want.
The setting is entered automatically.
4 Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter Initial setting
L
R
(FRONT) LARGE*
C
(CENTER) LARGE*
SL
SR
(SURROUND) LARGE*
SW
(SUB WOOFER) S.W. XXX YES*
L
R
DIST. XX.X m (ft.)** 5.0 m (16 ft.)**
C
DIST. XX.X m (ft.)** 5.0 m (16 ft.)**
SL
SR
DIST. XX.X m (ft.)** 3.5 m (11 ft.)**
SL
SR
PL. XXX BEHD.
SL
SR
HGT. XXX LOW
* You can set this parameter only when you select
NORM. SP.
** Models of area code U, CA only.
45°
90°
20°
A A
B
CC