Filter
Top Products
Getting Started
10
GB
Storing FM Stations
Automatically in Alphabetical
Order (“Auto-betical”)
With “Auto-betical select” you can automatically store
up to 30 FM and FM RDS stations in alphabetical order
without redundancy. Additionally, “Auto-betical
select” only stores the stations with the clearest signals.
If you want to store FM or AM (MW) stations one by
one, see “Presetting Radio Stations” on page 14.
FM RDS stations are stored first, in alphabetical order
by their Station Name, followed by regular FM stations
in order of frequency. (For more details on RDS, see
page 15.)
1 Press ?/1 (power) to turn off the receiver.
2 Hold down MEMORY and press ?/1 (power) to
turn the receiver on.
”AUTOBETICAL SELECT” appears and the
receiver scans and stores all the FM and FM RDS
stations in the broadcast area.
“FINISH” appears when the receiver has finished
storing the FM and FM RDS stations.
To change a preset code to another station
See ”Presetting Radio Stations” on page 14.
To stop Auto-betical before storing all the stations
Press ?/1 (power) to turn the receiver off.
Stations currently stored in the preset memory are
shifted to the rear (toward C0) and may be erased,
depending on the number of stations received by Auto-
betical select.
Notes
• If you move to another area, repeat this procedure to store
stations in your new area.
• For details on tuning to the preset stations, see page 14.
• Once “FINISH” appears, all the previous preset memories
are cleared. Preset AM stations again if necessary.
Before You Use Your Receiver
Before turning on the receiver, make sure that you have:
• Set the SPEAKERS button to ON.
Before you use your receiver for the first time or when
you want to clear the receiver's memory, do the
procedure below:
MUTING
DIMMER
1 Turn off the receiver.
2 Press ?/1 (power) for more than 4 seconds.
“INITIAL” appears in the display and the items
including the following are reset or cleared:
• All preset stations are reset to their factory
settings.
• All sound field parameters are reset to their
factory settings.
• All index names (of preset stations and
programme sources) are cleared.
• All adjustments made with the SET UP button are
reset to their factory settings.
• The sound field memorized for each programme
source and preset station is cleared.
Turn on the receiver and check the following indicator.
• Press MUTING if the MUTING indicator turns on.
• Press DIMMER repeatedly to set the display at any
of four levels of brightness.
?/1 (power)