Filter
Top Products
100
GB
x INSTALLER MODE
(RS232C control)
Normally, set this to OFF.
•ON
The receiver can receive commands from the
RS232C port.
•OFF
The receiver does not receive commands
from the RS232C port.
x 12V TRIG. MAIN
(12 V trigger for the main
receiver)
Lets you turn the external equipment on or off
by outputting 12V triggers when the receiver is
turned on or off. For example, you can
automatically unroll your video screen when
you turn on the receiver.
•OFF
Lets you turn off output of 12V triggers even
when the main receiver is turned on.
•CTRL
Lets you turn the output of 12V triggers on
or off manually using the CIS command of
the IR remote or RS232C control.
• ZONE
Lets you turn the output of 12V triggers for
the main zone on or off.
• INPUT
Lets you turn on the output of 12V triggers
when the preset input is selected.
To set the 12V trigger setting for
each input
The initial setting of TAPE/CD-R, MD/DAT,
SA-CD/CD, TUNER, and PHONO is “OFF.”
The setting of TUNER is applied to the FM,
AM, and XM Radio.
The initial setting of VIDEO 1-3, DVD, TV/
SAT, and HDMI 1 and 2 is “ON.”
1 Select “INPUT” in “12V TRIG. MAIN.”
2 Press to enter.
3 Press V/v to select the input, then
press
to enter.
4 Press V/v to select “ON” to activate the
12V trigger or select “OFF” to
deactivate it.
5 Press to enter.
6 Repeat steps 3 to 5 when you want to
make other settings.
Custom install mode parameters