Filter
Top Products
GBGB
Basic Operations
Getting Started
7
EN
TC-KA6ES/KA3ES
Amplifier
Hooking Up the System
This section describes how to hook up the tape deck to
an amplifier. Be sure to turn off the power of each
component before making the connections.
Hookups
When connecting an audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Connect the tape deck to the amplifier as shown
below.
Unpacking
Check that you have received the following supplied
items:
• Remote commander (remote) RM-J701 (1)*
• Size AA (R6) batteries (2)*
• Audio connecting cord (2)
* Canadian model only
Inserting batteries into the remote (Canadian
model only)
Insert two size AA (R6) batteries, matching the + and –
on the batteries with the markings inside the battery
compartment. When using the remote, point it at the
remote control sensor g on the tape deck.
Tape deck Amplifier
/
/
to LINE OUT
to TAPE INto REC OUT
to LINE IN
to a
wall outlet
to an AC outlet
(or a switched
outlet on the
amplifier when
using a timer)
When to replace batteries
With normal use, the batteries should last for about 6
months. When the remote no longer operates the tape
deck, replace all the batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting equipment. Doing so may cause a malfunction.
• If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
REC OUT IN
Ç
ç
L
R
L
R
LINE
OUTIN
TAPE
L
R
L
R
(Continued)