Filter
Top Products
Operations Using the Remote RM-PG413
masterpage:Right
lename[D:\foreigner\SEM_Janet\Revised
D
E897_Data\J9031709_4253072111DE897U\4253072111\GB08REM_STR-DE897-U.fm]
53
GB
model name1[STR-DE897]
[4-253-072-11(1)]
Tip
If programming is unsuccessful, check the following:
– If the indicator does not light up in step 1, the
batteries are weak. Replace both batteries.
– If the indicator lights up 4 times in quick
succession in step 3, an error has occurred. Start
again from step 1.
To cancel programming
Press RM SET UP during any step. The remote
automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3,
• Press M1 (TV/SAT) when the macro setting
is M1.
• Press M2 (TAPE) when the macro setting is
M2.
1 second delay is programmed at this program
step. The indicator lights up twice slowly, then
the remote automatically exits the macro setting
mode.
To clear the programmed IR
codes
Clear each macro step individually. In step 3,
• Press M1 (TV/SAT) when the macro setting
is M1.
• Press M2 (TAPE) when the macro setting is
M2.
The IR code is cleared. The indicator lights up
twice slowly, then the remote automatically
exits the macro setting mode.
To start macro play
Press M1 (TV/SAT) or M2 (TAPE) while the
ALT indicator turns on.
Note
If the Macro Play function does not work properly,
program a delay between each operation. See “To
delay the output of an IR code”.
GB01COV_STR-DE897-U.book Page 53 Wednesday, March 3, 2004 4:29 PM