Filter
Top Products
Hooking Up the Components
13
GB
CONTROL A1
G
CONTROL
A1 II
Y
P
B
/B – Y
P
R
/R – Y
TV/SAT IN DVD/LD IN
MONITOR
OUT
S–VIDEO
OUT
S–VIDEO
OUT
VIDEO OUT
S–VIDEO
IN
S–VIDEO
IN
S–VIDEO
IN
VIDEO INVIDEO OUT
AUDIO INAUDIO OUT
VIDEO INVIDEO OUT
AUDIO IN
VIDEO IN
AUDIO IN
VIDEO IN
AUDIO IN AUDIO OUT
PHONO
CD/SACD
MD/TAPE
L
R
L
R
IN IN INOUT
FM
75Ω
COAXIAL
y
CD/
SACD
IN
MD/
TAPE
IN
MD/
TAPE
OUT
TV/SAT
IN
DVD/LD
IN
COAXIAL
SIGNAL GND
y
AM
ANTENNA
DIGITAL
OPTICAL
MULTI CH IN
DVD/LDTV/SAT
VIDEO 2 VIDEO 1
L
R
L
R
L
R
L
R
FRONT SURROUND
SUB
WOOFER
CENTER
COMPONENT VIDEO
MONITOR
SURR
BACK
SUB
WOOFER
PRE OUT
Other hookups
CONTROL A1 hookup
• If you have a CONTROL A1 compatible
Sony CD player, SACD player, tape
deck, or MD deck
Use a monaural mini-plug cord (not
supplied) to connect the CONTROL A1
jack on the CD player, SACD player, tape
deck, or MD deck to the CONTROL A1
jack on the receiver. Refer to “CONTROL
A1
control system” on page 43 and the
operating instructions supplied with your CD
player, SACD player, tape deck, or MD deck
for details.
Note
If you make CONTROL A1 connections from
the receiver to an MD deck that is also connected
to a computer, do not operate the receiver while
using the “Sony MD Editor” software. This may
cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer’s COMMAND MODE
selector can be set to CD 1, CD 2, or CD 3,
be sure to set the command mode to “CD 1”
and connect the changer to the CD jacks on
the receiver.
However, if you have a Sony CD changer
with VIDEO OUT jacks, set the command
mode to “CD 2” and connect the changer to
the VIDEO 2 jacks on the receiver.