Filter
Top Products
49
Additional Information
No sound or only a very low-level sound is heard
from the rear speakers.
/ Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/ Select a sound field from the CINEMA or
VIRTUAL 3D genres (except MONO MOVIE and
STEREO MOVIE) (see page 30).
/ Adjust the speaker volume (see page 20).
/ Make sure the rear speaker size parameter is set to
either SMALL or LARGE (see page 17).
Recording cannot be done.
/ Check that the components are connected correctly.
/ Select the source component with a FUNCTION
button.
/ When recording from a digital component, make
sure the input mode is set to ANALOG (see page
25) before recording with a component connected
to the analog MD/DAT or TAPE terminals (STR-
DE925) or the analog TAPE/MD terminals (STR-
DE825).
/ When recording from a digital component, make
sure the input mode is set to DIGITAL (see page
25) before recording with the component
connected to the DIGITAL MD/DAT OUT
terminals (STR-DE925) or the DIGITAL TAPE/MD
OUT terminals (STR-DE825).
Radio stations cannot be tuned in.
/ Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
/ The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
/ Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning)
(see pages 41 and 51).
/ No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (see page 42).
/ Press DISPLAY so that the frequency appears in
the display.
The surround effect cannot be obtained.
/ Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/ Make sure that the SPEAKERS selector is set to A
or B (not A+B) if you connected two sets of front
speakers.
No picture or an unclear picture appears on the
TV screen or monitor.
/ Select the appropriate function on the receiver.
/ Set your TV to the appropriate input mode.
/ Move your TV away from the audio components.
The remote does not function.
/ Point the remote at the remote sensor g on the
receiver.
/ Remove any obstacles in the path between the
remote and the receiver.
/ Replace both batteries in the remote with new
ones, if they are weak.
/ Make sure you select the correct function on the
remote.
/ If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the receiver or other
component.
Reference sections for clearing the
receiver’s memory
To clear See
All memorized settings page 21
Customized sound fields page 37