Filter
Top Products
27
The CD Player
x
Tips
• If you want to record from the reverse side, press
TAPE B n to light its indicator after pressing
REC PAUSE/START in step 3.
• When you want to reduce the hiss noise in low-level
high-frequency signals, do the following procedure
after pressing REC PAUSE/START in step 3.
1 Press MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
2 Move the multi stick toward b or B repeatedly
to select “TAPE Set Up ?”, then press PUSH
ENTER.
3 Move the multi stick toward b or B repeatedly
to select “DOLBY NR Set Up ?”, then press
PUSH ENTER.
4 Move the multi stick toward b or B repeatedly
to select “On”, then press PUSH ENTER.
“DOLBY NR” appears in the display.
To return to the original setting, repeat steps 1
through 4 and select “Off” in step 4.
• When recording from a CD, you can use . or
> to select tracks during rec pause mode (after
pressing REC PAUSE/START in step 3 and before
pressing again in step 8).
Recording a CD by
specifying track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programming, make sure
the playing times for each side do not exceed the
length of one side of the tape.
?/1
(Power)
2
Multi stick
PUSH ENTER
12
1
117
continued
3,13
The Tape Deck
10