Filter
Top Products
Basic Operations
19
Tips
• Pressing TAPE A (or TAPE B) N or n when the
power is off automatically turns the power on and
starts tape playback if there is a tape in the deck
(One Touch Play). When the system is in the Power
Saving Mode, the One Touch Play function does
not work.
• You can switch from another source to the tape
deck just by pressing TAPE A (or TAPE B) N or
n (Automatic Source Selection).
• When you want to reduce the hiss noise in low-level
high-frequency signals, do the following procedure:
1 Press MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
2 Move the multi stick toward b or B repeatedly
to select “TAPE Set Up ?”, then press PUSH
ENTER.
3 Move the multi stick toward b or B repeatedly
to select “DOLBY NR Set Up ?”, then press
PUSH ENTER.
4 Move the multi stick toward b or B repeatedly
to select “On”, then press PUSH ENTER.
“DOLBY NR” appears in the display.
To return to the original setting, repeat steps 1
through 4 and select “Off” in step 4.
Searching for the beginning of a
track (AMS*)
During playback, press . or > repeatedly to
go forward in the same direction as the n or N
indicator. Press . or > repeatedly in the
opposite direction to go back.
The search direction, + (forward) or – (back), and
number of songs being skipped (1~9) appear in the
display.
Example: searching forward 2 songs
* AMS (Automatic Music Sensor)
Notes
• The deck stops automatically after repeating the
sequence five times.
• The AMS function may not operate correctly under
the following circumstances:
– When the unrecorded space between songs is
less than 4 seconds long.
– If completely different information is recorded
on the left and right channels.
– When there are continuous sections of
extremely low level or low frequency sound
(like those of a baritone sax).
– When the unit is placed near a television. (In
this case, we recommend moving the unit away
from the television or turning off the television.)