Filter
Top Products
Getting Started
11
Adjusting the speaker volume
of each speaker
— Test tone
1 Press PRO LOGIC.
“DOLBY PL ON” appears.
2 Press TEST TONE on the remote.
The test tone is heard from the speakers in
the following order.
Front (left) t Center t Front (right) t
Rear t Front (left) t
…
3 From your listening position, press
CENTER (+/–) and REAR (+/–) on the
remote to adjust the volume until the
each volume level becomes the same.
4 Press TEST TONE when you finish
adjusting.
The test tone turns off.
Note
The test tone feature works only for Dolby Pro Logic
Surround sound.
Setting the time
1 Turn on the system.
2 Press TIMER SET.
When you set the clock for the first time, go
to step 5.
3 Press – . or > + repeatedly to
select “CLOCK SET”.
4 Press ENTER.
5 Press – . or > + repeatedly to set
the hour.
6 Press ENTER.
7 Press – . or > + repeatedly to set
the minute.
8 Press ENTER.
Tip
If you made a mistake or want to change the time,
start over from step 1.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.