Filter
Top Products
– 32 –
“CPLAY MID” n “CPLAY OUT” n “CPLAY IN”
“CPLAY MID” n “CPLAY OUT” n “CPLAY IN”
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2Rotate the AMS knob and display “CPLAY MODE” (C30).
3Press the YES button to change the display to “CPLAY MID”.
4When access completes, the display changes to “C1 =
AD = ”.
Note : The numbers “
” displayed show you error rates and ADER.
2. Changing the parts to be played back
1Press the YES button during continuous playback to change the display as below.
When pressed another time, the parts to be played back can be moved.
2When access completes, the display changes to “C1 =
AD = ”.
Note : The numbers “
” displayed show you error rates and ADER.
3. Ending the continuous playback mode
1Press the MENU/NO button. The display will change to “CPLAY MODE”.
2Press the §EJECT button to remove the disc.
Note : The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1Set a recordable disc in the unit.
2Rotate the AMS knob and display “CREC MODE”.
3Press the YES button to change the display to “CREC MID” (C31).
4When access completes, the display changes to “CREC (
” and REC lights up.
Note : The numbers “
” displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1When the YES button is pressed during continuous recording, the display changes as below.
When pressed another time, the parts to be recorded can be changed. REC goes off.
2When access completes, the display changes to “CREC (
” and REC lights up.
Note : The numbers “
” displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1Press the MENU/NO button. The display changes to “CREC MODE” and REC goes off.
2Press the §EJECT button to remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2 :The MENU/NO button can be used to stop recording anytime.
Note 3 :Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 :During continuous recording, be careful not to apply vibration.
4-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the MENU/NO button immediately to exit it.