Filter
Top Products
Basic Operations
10
EN
6
Press r REC.
The deck becomes ready to record.
7
Adjust the recording level.
When recording through the DIGITAL COAXIAL IN, OPTICAL IN1, or
IN2 connector
Adjust the outer REC LEVEL (DIGITAL) control so that the
peak level meter in the display is a maximum of 0 dB. For
details, see page 15.
When recording through the LINE (ANALOG) IN jacks
Setting the inner REC LEVEL (ANALOG) control at 4 is
satisfactory for most purposes. For details, see page 15.
8
Press · or P.
Recording starts.
9
Start playing the program source.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press § EJECT to take out the MD or change the
deck to standby by pressing 1 /u . “TOC Writing” will flash in the display at
this time.
After “TOC Writing” stops flashing and goes out, you can pull out the AC
power cord.
To Press
Stop recording p
Pause recording* P. Press the button again or press · to resume
recording.
Take out the MD § EJECT after stopping
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
When “TOC Writing” flashes in
the display
The deck is currently updating the
Table Of Contents (TOC). Do not
move the deck or pull out the AC
power cord. Changes to an MD
made through recording are saved
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing the
1/u switch.
Rear of the disc
Record-protect tab
Slide the tab in the
direction of arrow