Filter
Top Products
Optional Components/Additional Information
27
AM antenna
Connect a 6- to 15- meter (20- to 50- feet)
insulated wire to the AM antenna terminal.
Leave the supplied AM loop antenna connected.
Insulated wire (not supplied)
Important
If you connect an external antenna, connect the
ground wire to the U terminal. To prevent a gas
explosion, do not connect the ground wire to a gas
pipe.
continued
Additional Information
Precautions
On safety
• The system is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned off.
• Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• The AC power cord must be changed only at the
qualified service shop.
• When you connect the AC power cord to the wall
outlet (mains), even though the power is off, the
system begins charging for remote and timer
functions. Therefore the surface of this unit
becomes warm, this is normal.
• The nameplate indicating operating voltage, power
consumption, etc. is located at the rear.
On placement
• Place the system in a location with adequate air
circulation, and do not place anything on the
system.
• Place the system in a location with adequate
ventilation to prevent heat build up.
• Do not place the system in an inclined position.
• Do not place the system in locations where it is;
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight.
On installing
When you move the system, remove all discs.