Filter
Top Products
16
Falling asleep to music
— Sleep Timer
You can set the system to turn off after a
certain time, so that you can fall asleep to
music.
Press SLEEP on the remote to select a
desired time.
Each time you press the button, the minute
display (the turn-off time) changes cyclically as
follows:
AUTO* t 90MIN t 80MIN t 70MIN t
…
t 10MIN t OFF
* The system automatically turns off after the current
CD finishes playing (up to 100 minutes).
When the function is TUNER, the system turns off
in 100 minutes.
Other Operations
To Press
Timer
Check the
remaining time
SLEEP on the remote once.
Change the time
to turn off
SLEEP on the remote repeatedly to
select the time you want.
Cancel the Sleep
Timer function
SLEEP on the remote repeatedly
until “OFF” appears.
Note
When the Sleep Timer is used, you cannot use the
Daily Timer.
Waking up to music
— Daily Timer
You can wake up to music at a preset time.
Make sure you have set the clock (see “Setting
the time” on page 10).
1 Prepare the sound source you want to
play.
• CD: Place a CD. To start from a
specific track, make a program (see
“Programing CD tracks” on page 12).
• Radio: Tune in a station (see
“Listening to the radio” on page 14).
• Tape: Make the same setting on the
timer of the component connected to the
PC/TAPE jacks.
2 Press VOL – or + to adjust the volume.
3 Press CLOCK/TIMER SET on the
remote.
4 Press . or > repeatedly until
“TIMER SET” appears, then press
ENTER on the remote.
The hour indication flashes.
5 Set the time to start playing.
Press . or > repeatedly to set the
hour, then press ENTER on the remote.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER on the remote.
The hour indication flashes again.
6 Set the time to stop playing following
the procedure in step 5.
The sound source indication flashes.