Filter
Top Products
12
Find a point in
a track
Cancel Program
Play
Press PLAY MODE on the
remote repeatedly until “PGM”
and “SHUF” disappear.
Clear the entire
program
Press x in stop mode.
Select the desired
track using
number buttons
Press number buttons on the
remote instead of performing
steps 3 to 5.
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press
NX (or CD N on the remote).
• When the total playing time has exceeded
100 minutes, the time is not displayed and the total
number of programed tracks is displayed.
Playing a CD (continued)
Stop play Press x.
Pause Press NX (or X on the remote).
Press again to resume play.
Select a track Press . or > repeatedly until
you find the desired track.
Other Operations
To Do this
Keep pressing m or M during
play and release it at the desired
point.
Remove a CD Touch OPEN/CLOSE Z (or press
OPEN/CLOSE Z on the remote).
Play repeatedly
(Repeat Play)
Press REPEAT on the remote
during play until “REP” or
“REP 1” appears.
REP: For all the tracks on the CD.
REP 1*: For a single track only.
To cancel playing repeatedly, press
REPEAT on the remote until
“REP” or “REP 1” disappears.
* You cannot repeat only one track during Shuffle
Play and Program Play.
Tip
If you press a number button on the remote, the track
corresponding to the pressed number on the disc starts
playing (Track Direct Play).
To enter track number 10 or over
on the remote
1 Press >10.
2 Enter the corresponding number buttons.
To enter 0, press 10/0 instead.
Example:
To enter track number 30, press >10, then 3 and 10/0.
Notes
• Do not forcibly press the disc down with your
finger, as this may cause CD player trouble.
Furthermore, do not obstruct the ejecting CD. Be
sure to touch OPEN/CLOSE Z (or press OPEN/
CLOSE Z on the remote) to lower the disc tray.
• The disc tray will not operate if you touch OPEN/
CLOSE Z while wearing gloves. Touch OPEN/
CLOSE Z with bare hands or press OPEN/
CLOSE Z on the remote.
Programing CD tracks
— Program Play
You can make a program of up to 24 tracks.
1 Press FUNCTION repeatedly to switch
the function to CD.
2 Press PLAY MODE on the remote
repeatedly until “PGM” appears.
3 Press . or > repeatedly until the
desired track number appears.
Playing time of the selected track
Track number
4 Press ENTER on the remote.
The track is programed.
The total playing time of the program and
the number of the last programed track are
displayed.
5 To program additional tracks, repeat
steps 3 and 4.
6 Press NX (or CD N on the remote).
Other Operations
To Do this