Filter
Top Products
18
Tips
•If you press TAPE nN (or TAPE hH on the
remote) when the power is off, the system
automatically turns on and starts playing the tape
if there is a tape in the holder (One Touch Play).
•To switch to the tape while listening to another
source, press TAPE nN (or TAPE hH on the
remote) while the tape is stopped. The tape will
automatically start playing (Automatic Source
Selection).
•To play a tape recorded with the Dolby NR
system, press DOLBY NR on the remote before
step 4. “;” appears.
Press TAPE EJECT A.
Stop playback Press TAPE x (or x on the
remote).
Adjust the volume
Pause Press TAPE X (or X on the
remote). Press again to
resume playback.
Fast-forward or
rewind
With the tape stopped‚
press TAPE M (or J on
the remote) or TAPE m
(or j on the remote).
Remove or replace
the tape
Turn VOLUME (or press
VOL +/– on the remote).
To Do this
Playing a tape (continued)
The CD Player
Checking the remaining
playing time on the CD
Do the procedure below to check the
remaining playing time of the current track or
the entire CD.
DISPLAY
, Press DISPLAY.
Each time you press this button, the
display changes as follows:
During playback
t Current track number and elapsed
playing time of the track
r
Current track number and remaining
playing time of the track
r
Remaining playing time of the entire CD
r
Clock display
Tip
Each time you press DISPLAY while the CD (or
tape) is stopped, the display changes as follows:
t Total playing time
r
Clock display
r
Current source display
Note
If the CD contains 25 tracks or more, the remaining
playing time of the current track will appear as
“- - - . - -” for each track starting with the 25th.