Filter
Top Products
Basic Operations
15
Tips
•If you press TUNER BAND (or TUNER/BAND on
the remote) when the power is off, the system
automatically turns on and tunes in the station last
received (One Touch Play).
•To switch to the radio while listening to another
source, press TUNER BAND (or TUNER/BAND
on the remote) (Automatic Source Selection).
•If there is static during an FM broadcast, press
STEREO/MONO on the remote until “MONO”
appears. After “MONO” scrolls across the display,
the frequency will appear. The broadcast will no
longer be in stereo, but the reception will improve.
Press this button again to restore the broadcast to
stereo.
•To improve the reception, adjust the supplied
antennas or connect an external antenna (see
“Connecting external antennas” on page 9).
Recording from the
radio
Do the procedure below to tune in a preset
station (see page 14) and record from the
radio to a tape. Both Type I (normal) and
Type II (CrO2) tapes can be used.
To turn on the system, press ?/1.
A
bB x
mM
Xz
A
ux
+
–
?/1
.
>
m
M
4312
856
TAPE x
?/1
x
7
j/J
TUNING/
PLAY MODE
TUNER/
BAND
X
z REC
DOLBY NR
1 Press TUNER.
“TUNER” appears.
continued
?/1
(Power)