Sony CDP-XA20ES Stereo System User Manual


 
18
EN
Additional Information
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
Check that the player is connected securely.
Make sure you operate the amplifier correctly.
Adjust the playback level using the LINE OUT/
PHONE LEVEL control (except for UK model).
The CD does not play.
There’s no CD inside the player. Insert a CD.
Use the stabilizer.
Place the CD with the label side up on the disc
tray correctly.
Clean the CD (see page 17).
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 17).
The recording level has changed.
When you connect the amplifier via the
VARIABLE LINE OUT jacks, the recording level
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording
(except for UK model).
The remote does not function.
Remove the obstacles in the path of the remote
and the player.
Point the remote at the remote sensor on the
player.
Replace all the batteries in the remote with new
ones if they are weak.
Specifications
Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Laser output Max 44.6 µW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ±0.3 dB
Dynamic range More than 100 dB
Harmonic distortion Less than 0.0023 %
Outputs
LINE OUT
(FIXED)
LINE OUT
(VARIABLE)
(except for UK
model)
DIGITAL
OUT
(OPTICAL)
DIGITAL
OUT
(COAXIAL)
(European and UK
models only)
PHONES
(except for UK
model)
General
Power requirements
Where purchased
USA/Canada
Europe/UK
Other countries
Power consumption 18 W
Dimensions (approx.) 430 × 125 × 350 mm
(w/h/d) (17 × 5 × 13 7/8 in.) incl. projecting
parts
Mass (approx.) 7.5 kg (16 lbs 9 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Stabilizer (1)
Design and specifications are subject to change without notice.
Power requirements
120 V AC, 60 Hz
220 V – 230 V AC, 50/60 Hz
110 V – 120 V or 220 V – 240 V AC,
adjustable, 50/60 Hz
Maximum
output
level
2 V
(at 50 kilohms)
2 V
(at 50 kilohms)
–18 dBm
0.5 Vp-p
(75 ohms)
28 mW
Jack
type
Phono
jacks
Phono
jacks
Optical
output
connector
Coaxial
output
connector
Stereo
phone
jack
Load
impedance
Over 10 kilohms
Over 50 kilohms
Wave length: 660
nm
75 ohms
32 ohms