Filter
Top Products
Additional Information 35
EN
Troubleshooting
Symptom
There is no audio.
“no disc“ lights in the display even
when a CD is in place.
The CD does not play.
The sound drops out.
The audio is weak or has poor
quality.
The audio is not stereo.
The picture of your TV becomes
unstable.
General
Remedy
• Press OPERATE to turn on the player.
• Connect the AC power cord to a wall outlet
securely.
• Connect the power cord to the POWER IN of
the player (page 26).
• Connect the audio connecting cord correctly
(page 27.)
• Adjust the volume.
• Unplug the headphones when listening through
speakers.
• Insert the CD with the label surface up.
• Make sure that the CD compartment is closed.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD compartment
open for about an hour to dry moisture
condensation.
• Press p on the CD section to switch the function
of the player to “Cd”.
• Reduce the volume.
• Clean the CD, or replace it if the CD is badly
damaged
• Place the player in a location free from
vibration.
• Move the player away from the TV.
• If you are using the remote while listening to
MW/LW radio, noise may be heard. This is
unavoidable.
• Press PLAY MODE/MONO/ST/ISS on the
player until “STEREO” appears.
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
continued
CD PlayerRadio