Filter
Top Products
The Timer 25
EN
The Timer
6 Set the timer to the hour and the minutes you want
to start recording.
1 Press 0/– or )/+
to set the hour and
press DISPLAY/
ENTER.
2 Press 0/– or )/+
to set the minutes and
press DISPLAY/
ENTER.
7 Set the timer to the hour and the minutes you want
to stop recording. (Do as step 6.)
8 Press 0/– or )/+ to set the volume you want,
and press DISPLAY/ENTER.
9 Press STANDBY.
The power goes off. The t indication and the
recording side of the tape (front side (()) appear
in the display.
At the preset time, the power will go on and the
recording will start. Then the power will go off at
the preset time, and the player will enter the
standby mode.
To check/change when the recording will start
Press TIMER/CLOCK, then DISPLAY/ENTER. Each
time you press DISPLAY/ENTER, a stored setting
lights up. Change the setting if you need to when the
setting lights up. When you finish checking, press
TIMER/CLOCK.
To listen to the radio, etc. before a timer-recording
starts
If you turn on the player, you can use it as usual.
Before the preset time, tune in the station you want to
record and turn off the power.
To stop timer-recording
Turn off the power.
Tips
• The preset settings
remain until you reset
them.
• When you select both
sides recording, the
recording will stop
after the both sides
recording finishes so
that accidental
recording will not be
made.
• The display window
does not light while the
recording timer is on.
Note
To change the
recording side of the
tape from the reverse
side (9) to the front
side ((), press
STANDBY to make the
t indication disappear,
and press STANDBY
again.